Dave303 / malatory

Using some thin aluminum I cut out my pieces trying to get a claw look, I know they wont be good for soft ground, but they are defently a little more scary. Lets look at how those peices fit together.

I would want to bend the claw peices out a little to cover mor ground and give it more a 3d look and feel. have the holes set to take the 6-32 screws, Might take that down to 4-40.

with the thicker aluminum, I start cutting one out using the piece of scrap from the top layer body part.

It is really not long before the peice starts getting to hot to do detail work. So I will cut a little here and there until Its done.

Next I need to start working on the aluminum spacers that I will used to hold the mobo to the acrylic and for keeping the body pieces a part. I will use the ones from the Body kit that I got from Lynxmotion to get the size down right.

It is time to stop for the night, so I will work some more later on this week. Not bad for a few nights work rolled out into one large update.

[Main] [Page 1] ... [Page 4] [Page 6] [ Page 7 ] [ Page 8 ]